Residential
Electric Door and Gate Operators

Commercial-Industrial
Trolley type-ceilling, Wall Mounts, B1-Parting, Sliding Doors Electric Operators

Waterproof
Trolley Type-Ceillling and Jack-Shaft-Wall Mount

Explosion-proof
Trolley Type-Ceillling and Jack-Shaft-Wall Mount

Sliding Gate
Electric Operators

Swing Gate
Electric Operators

Trafic control barriers
To control of vehicular traffic in private and public parking areas.

Rolling &Fire Doors
Rolling Service Doors & Fire Doors. Jack Shaft - Wall Mount

Accessories
Different accessories for your needs

Safety Devices
Reverse Systems and Sensor

Entry-Exit Devices
Loop Detectors, Card Reader and more

Operating Controls
 

Modifications
 

Special applications
 
 

9 REASONS WHY THE DOORLEC R-99 IS YOUR BEST DOOR OPERATOR INVESTMENT

1. Simpler to Install & Assemble:
Doorlec model R-99 is the ultimate garage door opener with all the features you expect and more. It offers security, by locking door when closed and the convenience of automatic opening. No printed circuits or solid state components. So reliable our model R-99 operator, that it will operate in below zero temperature or high humidity conditions. The pre-assembled trolley with a new and unique coupling system utilizes only three nuts, to totally assemble the Doorlec model R-99 door opener, saving you time and effort. In a short period of time and with a few tools, a layman will be able to install and have the Doorlec model R-99 garage door opener working.

2. Motor:
The motor is a powerful 1/3 H.P. 120 volt, single phase, with large 48 frame, permanently lubricated high-speed bearings for longer life, and has a high-efficiency operation rating of "continuous duty". Built into the operator is an external manual overload relay for overcurrent and under voltage protection. It can be manually reset without the removal of the enclosure.

3. Full Chain Drive:
High quality No. 65 roller chain will lift the heaviest residential door without fear of breaking.

4. Instant Reverse Obstruction Safety System:
Should door meet an obstruction when travelling towards the "CLOSE" position, the load sensing device built into the operator, will automatically reverse door to a fully "OPEN" position. If the push button, key switch or radio control is activated while door is closing, it will instantly reverse door and go back to a fully "OPEN" position. Should ice and snow accumulate on the garage floor (up to 2"), the garage door will close and stay closed.

5. Courtesy Light:
The full body length twin lighting system lights up a wide area when door opens or closes and stays on for three (3) minutes. Built-in time delay will automatically shut off lights.

6. Exterior Key Switch:
Heavy all steel construction electric key switch can be used to open and close garage door, if radio control transmitter is not available.

Radio Control:
Consists of a radio receiver mounted on the operator's radio terminal inside the garage and one or more hand-held transmitters. Digital coding permits you to select your own private "Electric key code". You can change this code at any time, simply by setting the dip switch to a new position on both receiver and transmitter.

Interior wall push button supplied with each operator. (Key switch, radio control optional at extra cost).

7. Open and Close Adjustments:
Easily accessible, by simply removing one light lens, and using your fingers, you can now adjust door travel in both directions, by turning the open & close adjustment knobs left or right.

8. Rugged all Gavanized Steel Construction:
Doorlec's model R-99 garage door opener utilizes all steel construction for greater strength and durability, all moving parts are made from high-quality steel. Galvanized means absolutely no "RUST" for years of worry free operation.

9. Shock Absorbing Lifting Arm:
Permanently attached to sliding carriage, it rides on high-tensile steel "T" bar. From floor level, a tug on a pull cord will detach arm from drive and allow manual operation in case of emergency such as power failure. To engage door with drive system, simply pull cord again, then activate operator with key switch, wall push button or radio control and the door will automatically travel either to "OPEN" or "CLOSE" position.

In addition for those high-torque starts, forceful closing of door, this arm is fitted with a shock absorbing spring to give longer life to both door and operator.


SPECIFICATIONS

Motor:
1/3 H.P., 1 phase, 60HZ, 48 frame. Permanently lubricated bearings, high-efficiency continuous duty.

Capacitor:
48 to 53 MFD. 115 to 120V. A.C. Dry electrolytic, non-polarized.

Limit Switches:
"Miniature" lever actuating snap action S.P.D.T. .250" quick connect terminals.

Motor Starting Relay:
Bistable. Contact rated at 15 amps. H.P. coil 24V. A.C. continuous duty rated.

Light Time Delay:
Adjustable, bi-metal heat sensing type.

Thermal Circuit Breaker:
Visibly accessible, manually reset glass cartridge fuse.
Interrupt capacity: 10 times rated current. Reset time: 10 - 60 seconds.
Maximum operating voltage: 250V. A.C.
.250" quick connect termination.


Transformer:
Class 2, totally enclosed in steel housing 120V prim. To 24V sec. 10 VA.

Unit Chassis:
12 ga. galvanized steel plate, pre-formed for greater strength.

Reduction:
From motor by a 1" (3.77cm) steel pulley to a balanced 9" (22.86cm) die cast aluminium alloy pulley by means of a 4L V-belt, which in turn rotates an output C.R. steel shaft 5/8" (1.60cm) in diameter, riding on permanent lubricated, self-aligning, high-speed bearings. Door operating speed 1,0ft (.3m) per second, approximately.

Twin-Sockets:
Easily accessible twin-sockets.
Accept standard bulb.
Recommended maximum 40 watts.


Plug Cord:
SJTW #18 - 3 conductors - 4ft long.

Trolley Assembly:
Comprises of 1" x 1" x 10' (3.77cm x 3.77cm x 304.80cm) high-tensile steel "T" bar.
Cast aluminium alloy carriage.
Full drive No. 65 roller chain.
65B9 idler sprocket with "oilite" bushing for longer life.
Front mounting bracket.
Nylon sleeve chain guide, for smooth and noiseless operation.
Coupling and reversing assembly with 1" permanently lubricated, high-speed bearing, for greater strength and endurance.

Operator Enclosure:
Molded "high-impact" flame retarded ABS plastic will not dent or crack if dropped. Full body length twin lens lighting for greater visibility. Snaps into place with absolutely no tools.

Door Arm:
1" X 3/16" (2.54cm X 0.4764cm) H.R. steel bar bent at 90o.
Permanently attached to trolley bar.
Adjustable to suit head-room and fitted with a shock absorbing door bracket, which allows door to settle tightly to floor. This unique door arm is equipped with a pull cord, which from floor level, if pulled, will disengage carriage from chain and will allow door arm to slide freely on "T" bar, so that the door may be operated manually in the event of an emergency, such as a power failure.

Shipping Weight:
25kg - 55lbs.

Size:
Operator head: 15" width x 21" long x 9" high.
Trolley:
4" x 6" x 122" for 7ft door.
4" x 6" x 133" for 8ft door.

All operators are factored-tested prior to shipment, in accordance with CSA requirements.

Enclosed with each unit are:
  • Wiring diagram
  • Installation and maintenance manual
DOORLEC CORPORATION is the leading Canadian Manufacturer of industrial and commercial electric operators for upward acting doors, sliding doors and gates. Over 30 years of experience and know-how have been put together in the designing, engineering and development of our residential garage door operator, DOORLEC MODEL R-99. Though combination of fine craftsmanship, styling, state of the art technology and comprehensive field testing, DOORLEC has produced the most rugged, simplest to install and service garage door operator in Canada. Because of the confidence in our years of experience to build quality and dependability in our operators, we offer the DOORLEC MODEL R-99 residential garage door opener with a 12 months warranty.